Programming Throwdown, Episode 66, Code Reviews.

Take it away, Jason.

Hey, everyone., Code Reviews. Take it away, Jason. Hey, everyone.

This is our double for this month because of my illness last month.

And one thing I did last month, even though I was quite sick, I was able to assemble a 3D

printer, which was actually super, super fun. I went on

Gear Best, which is some Chinese distributor, and I ordered a 3D printer kit. It was literally

just bags of screws and wires and rods and like this thing that had been cut out of acrylic like a bunch

of little acrylic pieces and some stepper motors that you could have got just right off the

shelf at fries or something but you know it came with the whole kit and it was very daunting.

I mean, the thing that scared me the most was at one point I pulled out of the box,

like a 120-volt plug that would plug into the wall.

And the other end was just three bare wires.

Don't stick them to your tongue.

Yeah, and I just thought, I mean, I'm not one of the people that, like,

put paper clips in the sockets when I was younger or something. And so that whole, like,

everything related to, like, electrical work, I just have no familiarity with. But I just dove in.

I knew that there were going to be a lot of good resources, and there are just an incredible

amount of resources on how to do it.

There's tons of videos from different angles, different people doing it.

And I built it and actually worked.

It was a little bit scary.

...